hey i was wondering if anyone could help me out with a how to on installing A/F ratio, and oil pressure (electric) i just want to make a clean install. i also dont know where the other O2 sensor is in my car, besides the one next to the resinator. any posts will help thanks :thumbsup:

also for the guage pod do i just drill those screws right into my pillar!? (after i take the old one out) are they self tap in screws?

I'm in the process of doing that to my car right now. Use a 1/8" drill bit, maybe a 5/32" drill bit and drill the two places where the holes are for the new pillar. there's not enough room to mark the location, so i just used a nail and scratched the location on there. Then just follow the instructions provided. the O2 sensor is behind the spark plug wires, close to the firewall, about in the middle of the engine. the oil sensor is near the bottom of the engine by the oil filter. If i can get a scanner, i can scan in some data sheets i printed out from school pertaining to this topic.
Also, it is a heated O2 sensor