Aleromod.com

Aleromod.com (http://www.aleromod.com/forums/forum.php)
-   Forced Induction Performance (http://www.aleromod.com/forums/forumdisplay.php?f=59)
-   -   Operation Overkill (http://www.aleromod.com/forums/showthread.php?t=34872)

AleroB888 08-19-2015 10:01 PM

Finally got the nerve to do some scans on this thing. For ambient temps in the mid 80s, it did quite well. The "all data loaded" mode on the histogram shows no Knock Retard (KR) anywhere. That was a welcome surprise, and may be the best I've ever got under similar conditions. IAT was taken at the MAF inlet, not in the UIM as I prefer to do.
PSI peaked at about 11, and charge temp rise at the IAT sensor was 16 degrees:



The engine wear and tear has caught up with us, as the ongoing misfires I've had on #1 have gotten worse, and #3 and #4 are starting to join in. So it's been intermittantly throwing P 300 and P 141 codes, usually before it warms up. A couple times I did get a flashing SES, which after a short time things seemed to pop back into place and it ran "normally."


AleroB888 08-24-2015 11:28 PM

^ Well, maybe it's not as bad as I thought. Turned out I had a bad fuel pressure regulator. Replaced it with a stock 55 psi unit, and no flashing SES for 2 days. She really peps up once the ambient temps go below 80. Need to get a scan of the upshift into 3rd, which had a KR problem before. I think it needs a trip to the track :)

AleroB888 08-30-2017 09:57 AM

Quote:

Originally Posted by AleroB888 (Post 662201)
^ Well, maybe it's not as bad as I thought. Turned out I had a bad fuel pressure regulator. Replaced it with a stock 55 psi unit, and no flashing SES for 2 days. She really peps up once the ambient temps go below 80. Need to get a scan of the upshift into 3rd, which had a KR problem before. I think it needs a trip to the track :)


I did have a successful outing at the 1/8 mile track (Ohio Valley), 3 runs of about 8.5 seconds in Fall of 2015

I won't be able to progress on this project due to health reasons, or possibly not even drive cars for a long time. Posting on internet is very difficult now, but I'll put out new info when I can. The SC is off the car now, which is running but has misfire issues with the new engine. It's well past time to pass the torch on this project, but practical matters will make it a slow process.....


All times are GMT -4. The time now is 06:32 AM.

Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.