Aleromod.com

Aleromod.com (http://www.aleromod.com/forums/forum.php)
-   LA1 3400 Specific (http://www.aleromod.com/forums/forumdisplay.php?f=19)
-   -   Pinout of the ABS Connector? (http://www.aleromod.com/forums/showthread.php?t=38942)

Alerodriver17 11-06-2017 11:39 AM

Pinout of the ABS Connector?
 
Does anyone have the pinout for the ABS pump Connector? I just replaced the transmission in my Alero, and in the process, the ABS speed sensor harnesses got ripped in two but we soldered them back together and it worked for a while. But now the light is on from the moment the car is started and it used to only come on while turn the wheel while the car was in motion. With winter here soon and the first snow not far away. It would be very nice to have ABS and traction control. So my assumption is that the speed sensor harnesses lead directly to the pump, so I’m going to get new hubs and harnesses and run the harnesses directly to the ABS pump because I DO NOT want to pull a lot of the engine bay harness back to replace the speed sensor harnesses. So if I can do it this way that would be SO MUCH easier. So does anyone have the pinout for the ABS pump Connector so I can get this done?

Thanks!

MilzyZ34 11-30-2017 02:54 PM

are you referring to the EBCM? Electronic Brake Control Module? What kind of vehicle do you have? I assume it's an Alero, but what year, trim level, etc

Alerodriver17 12-09-2017 09:41 AM

Whichever module that the ABS wheel speed harnesses run to. I have a 1999 Alero GLS Coupe with the 3400.


All times are GMT -4. The time now is 07:19 AM.

Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.