k here it goes.

u will need a grinder with a cutoff wheel or a hacksaw will work to.

go to ebay and buy urself an 98-02 HONDA ACCORD CAI setup. u can get these from anywhere to $40-$50 shipped.

u will get 2 tubes. one is shaped like an L..... this is ur top tube. u will need to trim 6 inches or so off this tube. just line it up and trim till u get the length right.

the second tube is shaped like an S. trim the bottom curve off that has the 2 connections for vaccum lines. again its about 6 inches or so. just trim till u get it to fit.

u will need to get 1 or 2 bigger couplers to fit the tube onto ur MAF. and if u want to replace the accordian connection between the MAF and Throttle Body that comes stock on ur car..... just use another coupler between those 2 and get grommets from autozone to plug the IAT sensor into.

and there u have it. an intake nearly identical and as nice lookin as the "others" out there.

u guys can thank me later ;)

I'd love to see pictures!

finished product
1

top shot in car
2

filter in wheelwell
3

there y have it..... ill get pics of where to cut the pipe up in alittle bit. but u can just eyeball it and trim until u get it to fit perfect. its not hard at all.

unregistered users at GAGT cant access those pics just FYI...

^^^^ thanks. ill upload them later to here. to busy thinkin about turkey right now.

wow, that looks pretty good and a few less pieces than the APOC CAI.

SweetAlero99-Did you buy the accord intake for a V6 or the 4cyl.?