3500 swap in the works....
 

The time has come....3500 will get swapped in....port and polished upper and lower intake mani with 65mm TB and the S&S headers i have on the 3400..gonna swap them right over :) Going through WOT-tech

Good luck with the swap. Keep us posted

Full 3500 swap, or just top end?

Good luck man...

needs moar 5speed

When you're done, meet me at the track.... lets see how you fair against a 3400, wink, wink...

Full swap


LOL....you prob have yours all built up right? judging by the posts you make im assuming you do....if not, LETS GO! ;)

Yea its built. I was thinking you were building a 3500 and dropping it in. I am dying to see how I would do against a built 3500

Not really gonna build up the engine too much. just getting the upper and lower intake mani's port&polished, bigger tb, headers, exhaust. 200+ hp is enough for me. Canada is a little far a drive too...lol

good luck I wanna see this !!

K....im searching for possible sites to buy an engine from but i dont wanna just buy from ANY site....found this one.


http://www.psengines.com

then i did a little search and found a 3800 supercharged on there....no 3500 but im sure i could request one. There is a 97-05 buick built 3800 supercharged....its very tempting....but first i should talk to guild about how much goes into that swap.....both swaps i would need to do A LOT of work right? like swapping computers and stuff....$2,179 for the 3800:cry:

for the 3500 its pretty much a bolt in engine, all you need is the 65 mm TB and the adaptor, you also need the crank position sensor relocation kit avaiable from WOT

Nice....did you do the swap?

The 3500 uses a different MAP sensor...i think you'll need a pig tail to get it work.... PM 3500Alero he actually had this swap

You can get all the stuff you need for the swap at MilzyMotorSports.com.

not yet im not finished gathering all the parts i need, when i do mine its getting a 5 speed as well, you kno so all that power wont get soaked up by the auto tranny lol

my buddy has a ga 3.5 swapped with 5speed, motor was a direct swap tranny was a pain tho

yea not looking forward to the tranny thing

Okay ,sorry for being a total moron when it comes to the aleros v6 power plants since i my self got a 2.4l twin cam, don’t really know much more like nothing about those two engines. What exactly would be the benefit of doing this engine swap. Pleas enlighten me with the knowledge I seem to lack.

Better compression, better flow, better crank, and more HP. The G6 motor is essentially the same motor but it was a little redesigned internally with the crank, cylinder heads, and intakes. Plus stock it is a 200HP motor. The cool thing is everything bolts up the same minus a few sensors that have to be changed over.