Can someone post a how to or a link to how to remove the balance shafts from the LD9 please? I am pretty sure how to do it but not too sure if it's worth it.
|
I was just checking J-body.org and there are a few ppl on there who have done this, as far as I can tell it's not cheap or easy. You have to drill holes in a bare block for oil and then have to clean it properly to get the metal shavings out. anyone else care to add their 2 cents?
|
the balance shafts are part oiling system. you would need to do the 2.3 oil conversion.
http://www.ny-jbodies.org/forum/libr...2.3oilconv.htm |
All times are GMT -4. The time now is 10:33 PM. |
Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.