name of trim on side of windshield
 

i was checking gmparts site for this part. on our cars we have a trimp piece that goes down the side of the passanger and one down the side of the drivers. my drivers flew off on the highway. on their site it doesnt really show them though. something kind of like them but they say its $73 cant be though it dowsnt look like the piece and it cant cost that much wouldnt make sense? anyone know what this trim piece is called?

i dont remember what its called, but it is a dealer only part and is very pricy at the 3 dealers i asked about. Its only purpose is to cover that vally in the window, nothing else, if you really want to replace it find one at a junkyard and save some money.

the black plastic part that covers up the edge of the windshield? should be about $12 each. I had to replace my passenger side one twice. 3 screws.

Outer Reveal Molding.

cliff the outer reveal screws into the side but does it also cover the edge of the windshiled or does anyone know if it does?

Yeah, it covers the edges.

your the man aparently the dealer wasnt sure said i couldnt order till i kew for sure they claimed it only srewed into the side that the part that cover the edge of windshiled is different i knew that didnt sound right though.

Yeah, mine has been replaced before. The original one came apart on the highway.

^^ That happened to me too

$10 at the junkyard, 5 minutes to take the old one off and put the new one on

should i put silicone in there too when i put new one on?

mine came a apart so i reglued the plastic peice and the rubber piece back together with some 3m weatherstrip and gasket adhesive and its sure holds better than the stock adhesive

If you're talking about the hard plastic/rubber piece that runs along the side of the windshield and the A-pillar--does that thing serve any purpose other than aesthetics? That piece on mine came loose sometime in 2007 and came off completely in early 2010. 1.5 years later, no leaks, so it can't be a water barrier. It's a little ugly but considering the condition of the clearcoat, I'm not worried about it. Unless it served some purpose that I haven't noticed the loss of.

The drivers side piece started to come off but I siliconed it in last year. Yesterday oin the thruway it came lose again and was flopping around as I was driving.

I hot glued it in this time n it seems to be holding nicely so far but only time will tell.

If it fils this time I'll try to use some rubber type cement more like the origianl glue used.

BTW I didn't see any screws holding it in. It seems to be a slot type snap-in affair with some glue to hold it in.

.

It is supposed to be held in by 3 screws. I just removed one from a car in a salvage yard yesterday.