Register
FAQ
Members List
Calendar
Search
Today's Posts
Mark Forums Read
Aleromod.com
>
Search Forums
Search Results
User Name
Remember Me?
Password
Page 1 of 2
1
2
>
Showing results 1 to 25 of 44
Search took
0.01
seconds.
Search:
Posts Made By:
Alero 2 Envy
Forum:
Common Questions & Troubleshooting
06-15-2008, 10:02 AM
Replies:
15
Anyone ever figure out the Vibration issue on 2.4
Views:
1,895
Posted By
Alero 2 Envy
Mine would shake and make noise also like the...
Mine would shake and make noise also like the prop rod was loose. But it took about 45mins to do the front mount and about 3 1/2 hours for the rear which was a pain in the ass. There is a bolt on the...
Forum:
Common Questions & Troubleshooting
06-14-2008, 09:50 PM
Replies:
15
Anyone ever figure out the Vibration issue on 2.4
Views:
1,895
Posted By
Alero 2 Envy
Well I guess no one has figured it out...
Well I guess no one has figured it out then....
I will share some info, I changed front and rear engine mounts and it purrs like a kitten now. No vibration at all, even with the A/C full blast. Who...
Forum:
Common Questions & Troubleshooting
06-13-2008, 10:54 AM
Replies:
15
Anyone ever figure out the Vibration issue on 2.4
Views:
1,895
Posted By
Alero 2 Envy
Anyone ever figure out the Vibration issue on 2.4
Ok I got a 1999 2.4 Auto with about 120,xxx miles. Done the major tune up which included new:
AC Delco plugs, boots, coil wire, and coils (didnt change coil housing)
Fuel filter
Air filter
FP...
Forum:
LD9 2.4L Twin Cam Specific
11-12-2007, 12:33 PM
Replies:
17
MY 2.4 (weird motor idle)
Views:
924
Posted By
Alero 2 Envy
My 2.4 Auto idles at 550-600, wish I could get to...
My 2.4 Auto idles at 550-600, wish I could get to idle at 700-800 because the rough idle goes away then. Drives me crazy and with the AC on it feels like the doors are going to fall off !
As for your...
Forum:
LD9 2.4L Twin Cam Specific
10-27-2007, 02:11 PM
Replies:
7
read this-great quad article
Views:
557
Posted By
Alero 2 Envy
I was comparing a factory car to factory car,...
I was comparing a factory car to factory car, only pointing out what I did with bolt ons. Yeah take away the turbo and you probally got a car making 140hp but from the fatory, but a stout forged...
Forum:
South
10-27-2007, 12:32 PM
Replies:
6
San Antonio, Bif Buzby's Friday 26th
Views:
1,023
Posted By
Alero 2 Envy
Im from S.A and go out to Biff's often ! Cool...
Im from S.A and go out to Biff's often !
Cool place and lots of nice cars, im usually in my SVO in the bottom sig. Last time there were 3 GT40's (2 newer and 1 older) and your usual supercharged...
Forum:
LD9 2.4L Twin Cam Specific
10-27-2007, 12:18 PM
Replies:
7
read this-great quad article
Views:
557
Posted By
Alero 2 Envy
[QUOTE=kottonmouth;311635] production quads...
[QUOTE=kottonmouth;311635]
production quads debuted in the 88' model year, the year before when olds 307 made 180hp in ho trim, a four banger with half the displacement and the same hp and trq...
Forum:
Common Questions & Troubleshooting
10-21-2007, 07:45 PM
Replies:
11
Problem: Installed new guage cluster, now my car has 58k miliage lol
Views:
466
Posted By
Alero 2 Envy
Mine did the same thing when I changed it...
Mine did the same thing when I changed it...
Forum:
Common Questions & Troubleshooting
10-03-2007, 10:34 PM
Replies:
8
How to pull Sterring wheel ?
Views:
406
Posted By
Alero 2 Envy
I used a regular 3 jaw puller on one at the junk...
I used a regular 3 jaw puller on one at the junk yard and ended up pulling it apart. It seperated from the steel ring that slips over the shaft.
Reason im trying to get it out is because I F'ed up...
Forum:
Common Questions & Troubleshooting
10-02-2007, 11:44 PM
Replies:
8
How to pull Sterring wheel ?
Views:
406
Posted By
Alero 2 Envy
How to pull Sterring wheel ?
Ok I have pulled them before but your typical wheel remover wont cut it nor will a jaw puller.
* What tool is used to pull the steering wheel off (proved link or pic if possible) ?
Forum:
LD9 2.4L Twin Cam Specific
08-15-2007, 12:01 PM
Replies:
5
2.4 DOHC RPM at Idle ?
Views:
450
Posted By
Alero 2 Envy
hhmmmm mine is at 550rpm when warmed up at idle,...
hhmmmm mine is at 550rpm when warmed up at idle, no wonder it shakes. Wonder what could cause this...
Forum:
LD9 2.4L Twin Cam Specific
08-11-2007, 03:05 PM
Replies:
5
2.4 DOHC RPM at Idle ?
Views:
450
Posted By
Alero 2 Envy
2.4 DOHC RPM at Idle ?
What does yours Idle at ?
I have a 99 2.4 Auto and idles like crap because of all the shaking it does. When I give it very little gas and raise the rpm to about 700 then all the shaking goes away....
Forum:
Common Questions & Troubleshooting
08-04-2007, 01:08 PM
Replies:
9
Fuel Pump not working??
Views:
367
Posted By
Alero 2 Envy
Check the wiring to make sure you didnt hit and...
Check the wiring to make sure you didnt hit and un plug something. I have changed my filter twice with no issues.
Forum:
Common Questions & Troubleshooting
08-03-2007, 11:37 AM
Replies:
6
Wheel alignment?
Views:
361
Posted By
Alero 2 Envy
Damn Strut bearings, thats right up there with...
Damn Strut bearings, thats right up there with your 30,000 interval change of muffler bearings. Thats guy is a BOZO !
:haha:
Forum:
Common Questions & Troubleshooting
07-13-2007, 05:17 PM
Replies:
5
difference between front and rear Pads?
Views:
304
Posted By
Alero 2 Envy
Looks like cheaper pads on the right. The more...
Looks like cheaper pads on the right. The more high dollar pads look like that on the left with more meat and the notch in the middle.
Forum:
Common Questions & Troubleshooting
06-25-2007, 03:32 PM
Replies:
2
Will O2 always throw CEL if bad ?
Views:
213
Posted By
Alero 2 Envy
Valve chatter fixed ! Bad knock sensor...
Valve chatter fixed !
Bad knock sensor connection. It was unplugged somehow, plugged back in and runs good. Still got the rough idle..
Forum:
Common Questions & Troubleshooting
06-16-2007, 02:01 PM
Replies:
2
Will O2 always throw CEL if bad ?
Views:
213
Posted By
Alero 2 Envy
Will O2 always throw CEL if bad ?
I have a 2.4 and got a rough idle but my car is not throwing any codes. I am thinking motor mounts as it only idles rough (Vibrates & Shakes) in Drive, 1st, 2nd and 3rd, does not in idle or reverse....
Forum:
Common Questions & Troubleshooting
06-07-2007, 02:13 PM
Replies:
20
Car shaking at Idle
Views:
933
Posted By
Alero 2 Envy
Any progress liquidX ?
Any progress liquidX ?
Forum:
Common Questions & Troubleshooting
06-02-2007, 08:26 AM
Replies:
20
Car shaking at Idle
Views:
933
Posted By
Alero 2 Envy
Before anyone starts throwing $$$ at there ride...
Before anyone starts throwing $$$ at there ride to figure it out. This is what I have changed, keep in mind I have not had a CEL come on since I bought my car:
* New AC Delco Double Plat plugs @...
Forum:
Common Questions & Troubleshooting
06-01-2007, 06:02 PM
Replies:
20
Car shaking at Idle
Views:
933
Posted By
Alero 2 Envy
1999 2.4 does the same annoying crap. I started...
1999 2.4 does the same annoying crap. I started thinking tranny mount since it only does it in forward gears. I can go into Nuetral, Park, and Reverse and it wont shake. As soon as I slip it into any...
Forum:
Common Questions & Troubleshooting
05-18-2007, 11:10 AM
Replies:
0
Coolant Leak (Drivers Side) ? 1999/2.4
Views:
230
Posted By
Alero 2 Envy
Coolant Leak (Drivers Side) ? 1999/2.4
Ok so I have had a small leak for about 1 month, coolant would go low and couldnt find where it was coming from. Last night it started leaking bad, good thing is I know from where. The housing on the...
Forum:
Common Questions & Troubleshooting
05-03-2007, 07:27 PM
Replies:
9
CV Half shaft ?
Views:
382
Posted By
Alero 2 Envy
I replaced the other side and the noise went...
I replaced the other side and the noise went away. It was the CV that was giving me grief ....
Forum:
Common Questions & Troubleshooting
04-25-2007, 03:56 PM
Replies:
2
ABS Light ?
Views:
231
Posted By
Alero 2 Envy
ABS Light ?
ABS light came on recently and does not go off. My horn is also not working so wondering if it has something to do with my sterring wheel components. Anyone had this problem ?
Forum:
LD9 2.4L Twin Cam Specific
04-05-2007, 02:36 PM
Replies:
7
Coolant Leak
Views:
1,445
Posted By
Alero 2 Envy
Yeah im good to her, only sees redline about 1...
Yeah im good to her, only sees redline about 1 time a month (on accident). Oil changes and frequent flushes keep her alive and kicking.
I have a turbocharged Mustang if I want to beat on...
Forum:
LD9 2.4L Twin Cam Specific
04-05-2007, 01:40 PM
Replies:
7
Coolant Leak
Views:
1,445
Posted By
Alero 2 Envy
I will check, for any water residue around there....
I will check, for any water residue around there. My car also has about 115,000 miles and nothing has been touched or change. Dreading the water pump change soon. No oil and water mix either.
Showing results 1 to 25 of 44
Page 1 of 2
1
2
>
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Main Forums
News & Updates
Alero Show & Stravaganza Info
Alero Show & Straveganza
Aleromod.com Showcase
Alero Of The Month
New Member Introductions
Site Sponsored Stores
Rock Auto
Regional Discussions & Meets
Canada
East Coast
Midwest
West Coast
South
International
General Help
Alero Appearance
Paint and Body Work
Common Questions & Troubleshooting
Audio, Video & Security
How-To Archive & FAQ
Product Reviews
Performance Related
General Performance
Forced Induction Performance
LA1 3400 Specific
LD9 2.4L Twin Cam Specific
L61 2.2L Ecotec Specific
At The Track
Aleromod Extras
Site Suggestions / Opinions
Aleromod Bazaar
The Bazaar - For Sale
The Bazaar - Want to Buy
Aleromod Freebies
All times are GMT -4. The time now is
12:57 AM
.
-- Default Style
-- speedfire
-- Approx+
-- Freshblue
Contact Us
-
Aleromod.com
-
Archive
-
Top
Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
vBulletin Skin by vBSkins.com