Aleromod.com Aleromod.com
 

Go Back   Aleromod.com > Search Forums
Reload this Page Search Results

Page 1 of 3 1 23 >
Showing results 1 to 25 of 65
Search took 0.01 seconds. Search: Posts Made By: BeeMain
Forum: Audio, Video & Security 11-18-2010, 05:50 PM
Replies: 6
Views: 627
Posted By BeeMain
it's there, if i remeber stright up from the...

it's there, if i remeber stright up from the brake pedal and a little to the left, more-or-less. total pain in the ass to get to but it's there. I think I poked a scrap wire through from the inside...
Forum: General Performance 09-07-2010, 03:28 PM
Replies: 45
Views: 3,169
Posted By BeeMain
23 city, 3400, 2003

23 city, 3400, 2003
Forum: Common Questions & Troubleshooting 03-12-2010, 04:11 PM
Replies: 31
Views: 4,468
Posted By BeeMain
pull off the film and use soap and water. A...

pull off the film and use soap and water. A small rubber bouncy ball works well to get off the glue (along with soap and water) and a new razor blade (make sure to have the window soaped at all...
Forum: Audio, Video & Security 02-18-2010, 01:43 PM
Replies: 37
Views: 1,886
Posted By BeeMain
Your amp takes a whisper from your headunit and...

Your amp takes a whisper from your headunit and turns it into a shout for your speakers.

headunit sends information via "RCA" cables to the amplifier. The amplifier, amplifies this low power signal...
Forum: General Performance 01-13-2010, 11:50 AM
Replies: 29
Views: 3,365
Posted By BeeMain
Haha, at least you know it

Haha, at least you know it
Forum: Audio, Video & Security 11-21-2009, 12:09 AM
Replies: 12
Views: 463
Posted By BeeMain
don't do that! just use the 4 channel you...

don't do that! just use the 4 channel you bought. 50W, 100W, whatever, not too likely your going to notice with your rear speakers. but whatever you do don't "piggy back them"

you could run the...
Forum: Audio, Video & Security 11-12-2009, 09:19 PM
Replies: 13
Views: 421
Posted By BeeMain
take a piece of 3/4" mdf that is larger than...

take a piece of 3/4" mdf that is larger than the port, glue and screw it over the port hole and it's sealed. You can't ruin a sub with a sealed enclosure, you can with an improperly ported enclosure...
Forum: New Member Introductions 11-04-2009, 05:41 PM
Replies: 32
Views: 5,111
Posted By BeeMain
are those Q forms? how is the imaging?

are those Q forms? how is the imaging?
Forum: Audio, Video & Security 10-14-2009, 02:16 PM
Replies: 140
Views: 15,448
Posted By BeeMain
very nice, why the change? I'd take them but I...

very nice, why the change? I'd take them but I have a 4 door
Forum: Audio, Video & Security 06-03-2009, 02:14 PM
Replies: 140
Views: 15,448
Posted By BeeMain
love it the doors and A pillars are perfect on...

love it
the doors and A pillars are perfect

on your website it looks like you mounted the speaker pods to the door and then made a cover that is mounted to the door skin. is this correct?
Forum: Audio, Video & Security 05-06-2009, 01:39 PM
Replies: 5
Views: 380
Posted By BeeMain
it has to be very shallow, like 2" max...

it has to be very shallow, like 2" max mounting depth or your going to be hitting the window crank ... and your spacer can't be too thick or the door panel doesn't go back on or even worse the door...
Forum: Audio, Video & Security 05-05-2009, 06:23 PM
Replies: 13
Views: 447
Posted By BeeMain
why are you splitting your RCA's? does your...

why are you splitting your RCA's? does your headunit have a front and back RCA's? lots of them have a sub rca as well, or 6 channels. what are your amps running? front/back? front/back/sub?
Forum: Audio, Video & Security 05-05-2009, 06:21 PM
Replies: 13
Views: 447
Posted By BeeMain
you should always have a fuse just off your...

you should always have a fuse just off your battery (within 18 inches or closer). If you are in an accident or do something stupid in the future and cut the power wire between the battery and the...
Forum: New Member Introductions 04-09-2009, 03:36 PM
Replies: 27
Views: 767
Posted By BeeMain
Leafs SUCK, hahahahahaha Go Flames Go

Leafs SUCK, hahahahahaha

Go Flames Go
Forum: Alero Appearance 04-08-2009, 03:52 PM
Replies: 425
Views: 23,213
Posted By BeeMain
I saw a guy yesterday in Calgary, Alberta Canada...

I saw a guy yesterday in Calgary, Alberta Canada with these, not sure it was the same brand but they were Altezza lights. it was black, custom rims, really loud going down elbow/sifton
Forum: Common Questions & Troubleshooting 04-08-2009, 01:07 PM
Replies: 15
Views: 636
Posted By BeeMain
get the codes checked at an auto parts store, it...

get the codes checked at an auto parts store, it will tell you which ABS sensor is fried (because that's most likely what it is). Then you can replace your hub assembly/sensor.
Forum: Common Questions & Troubleshooting 03-21-2009, 07:57 PM
Replies: 16
Views: 402
Posted By BeeMain
unless they hit the tiny little wire going to the...

unless they hit the tiny little wire going to the ABS sensors when installing your exhaust. It's a real POS and wouldn't take much to damage if it got hooked
Forum: Alero Appearance 03-20-2009, 05:59 PM
Replies: 121
Views: 3,870
Posted By BeeMain
good work, a little rough around the headlights. ...

good work, a little rough around the headlights. and no shit he needs side skirts, I'm sure he's aware of that.
Forum: Common Questions & Troubleshooting 03-07-2009, 04:36 PM
Replies: 7
Views: 549
Posted By BeeMain
gas cap was loose, oops, stupid full sevice...

gas cap was loose, oops, stupid full sevice jockey

Auto Value checked the code and reset if for me no cost, very nice of them.

The cheap ass garages up here would charge you the minimum of $65
Forum: Common Questions & Troubleshooting 03-03-2009, 11:57 AM
Replies: 7
Views: 549
Posted By BeeMain
good idea thanks "why must everything be a...

good idea thanks

"why must everything be a problem!!!!"
Forum: Common Questions & Troubleshooting 03-03-2009, 11:16 AM
Replies: 7
Views: 549
Posted By BeeMain
check engine light went on

went on this morning on the way to work. Temp, fine. didn't run out of oil, so that's fine, brakes/abs work, lights and all that work.

it's really wet and slushy here and I hit a pot hole, could...
Forum: Aleromod.com Showcase 02-26-2009, 07:01 PM
Replies: 110
Views: 7,939
Posted By BeeMain
that's the body kit you guys shudda made (not...

that's the body kit you guys shudda made (not that the OSV is bad)

What's with the "hook" going through the hood on the passengers side?

With all those details you think it's photoshop?
Forum: Audio, Video & Security 02-26-2009, 01:14 PM
Replies: 28
Views: 789
Posted By BeeMain
have a pic of how they fit on the drivers side?

have a pic of how they fit on the drivers side?
Forum: Audio, Video & Security 02-22-2009, 04:36 PM
Replies: 12
Views: 741
Posted By BeeMain
I tried modifying an installation kit to mount it...

I tried modifying an installation kit to mount it up-side-down, total pain and I gave up. I wanted to mount the deck on the bottom and have the pocket on the top solid so I could mount a portable XM...
Forum: Common Questions & Troubleshooting 02-21-2009, 07:32 PM
Replies: 10
Views: 467
Posted By BeeMain
I just took it out. It is located on the...

I just took it out. It is located on the steering column bracket on the RHS. You have to take the plastic pieces off the bottom of the dash (the one on the right is also part of the heater vent...
Showing results 1 to 25 of 65
Page 1 of 3 1 23 >

 
Forum Jump

All times are GMT -4. The time now is 06:53 AM.

Contact Us - Aleromod.com - Archive - Top

Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
vBulletin Skin by vBSkins.com