Aleromod.com Aleromod.com
 

Go Back   Aleromod.com > Search Forums
Reload this Page Search Results

Showing results 1 to 21 of 21
Search took 0.00 seconds. Search: Posts Made By: bigdoug42
Forum: General Performance 01-11-2014, 09:15 AM
Replies: 7
Views: 434
Posted By bigdoug42
Sorry. By connectors I meant metric brake line...

Sorry. By connectors I meant metric brake line tube union 3/16" line 10MM X 1." And the double flared end of the brake line was what I clipped off when I was tightening the 3/16" line metric brake...
Forum: LD9 2.4L Twin Cam Specific 01-10-2014, 04:38 PM
Replies: 9
Views: 1,543
Posted By bigdoug42
update......

I went ahead and replaced the engine with a re manufactured unit, along with the trans, so I have a drivetrain with essentially zero miles. This was my late wifes car, she passed away suddenly in...
Forum: General Performance 01-10-2014, 04:29 PM
Replies: 7
Views: 434
Posted By bigdoug42
update on brake line...

Replaced these with the copper nickel line, very easy to use, found out when attaching connectors you can't tighten them like steel line or you clip the flare right off. Either that or I just don't...
Forum: General Performance 09-29-2013, 02:27 AM
Replies: 7
Views: 434
Posted By bigdoug42
I like that idea, I think I'll run with it....

I like that idea, I think I'll run with it. Thanks!
Forum: General Performance 09-28-2013, 07:26 PM
Replies: 7
Views: 434
Posted By bigdoug42
right rear brake line-replace or repair?

Any http://www.gmpartseast.com/diagrams/large/36N/brake-hoses-pipes-mn0404003.png

The right rear brake line (#3) is corroded at the union (#s 10 and 11) and is leaking. This is in a very...
Forum: LD9 2.4L Twin Cam Specific 07-05-2013, 07:56 AM
Replies: 9
Views: 1,543
Posted By bigdoug42
Yes, that was it. I,m not saying he damaged it...

Yes, that was it. I,m not saying he damaged it somehow, its just that I know nothing about fwd trannies, and want to make certain I'm not missing anything. It had been idling rougher than normal...
Forum: LD9 2.4L Twin Cam Specific 07-04-2013, 10:36 AM
Replies: 9
Views: 1,543
Posted By bigdoug42
engine locked up...

Hi all its been awhile since I last posted. I have a 2001 Alero GL2 sedan in Ruby Red, with 157000 miles on it, bought it new in 2001 and its been a darn good car, up until the head gasket went to...
Forum: LD9 2.4L Twin Cam Specific 11-01-2011, 09:11 PM
Replies: 0
Views: 227
Posted By bigdoug42
its been awhile since I last posted...

Just wanted to say thanks to all those who answered the questions I had during the head gasket R&R, also ended up replacing T/C, water pump, All rubber hoses, water outlet, and all the other gaskets,...
Forum: LD9 2.4L Twin Cam Specific 08-15-2011, 01:39 PM
Replies: 7
Views: 362
Posted By bigdoug42
Got this fixed, it was apiece of the old tube...

Got this fixed, it was apiece of the old tube broken off inside the opening, got it out, new one slid right in. Damned hard to tell that piece of metal was stuck in there though. FWIW to anybody else...
Forum: LD9 2.4L Twin Cam Specific 07-16-2011, 11:22 PM
Replies: 7
Views: 362
Posted By bigdoug42
Thats what I understand also. Do the techs have,...

Thats what I understand also. Do the techs have, or does GM have a procedure or install tool for this that you know of?
Forum: LD9 2.4L Twin Cam Specific 07-16-2011, 07:35 PM
Replies: 7
Views: 362
Posted By bigdoug42
The old one was rusted in place, and the ones a...

The old one was rusted in place, and the ones a salvaged at a junkyards were also all rusted in and a bitch to get out. I did have one out of the 4 I've pulled come right out, like you say. It makes...
Forum: LD9 2.4L Twin Cam Specific 07-16-2011, 05:55 PM
Replies: 7
Views: 362
Posted By bigdoug42
installing oil dipstick tube

Hi all, I recently R&R'd a 2.4 Twin cam, (Head gasket), and while it was apart, replaced the timing chain, water pump, tensioner, all gaskets, seals, o rings, and hoses. Started it up and it runs...
Forum: LD9 2.4L Twin Cam Specific 04-11-2011, 06:55 PM
Replies: 2
Views: 420
Posted By bigdoug42
Thanks for the answer!

Thanks for the answer!
Forum: Aleromod.com Showcase 04-11-2011, 04:00 AM
Replies: 22
Views: 849
Posted By bigdoug42
guess I'm not the only nite owl, lol.

guess I'm not the only nite owl, lol.
Forum: LD9 2.4L Twin Cam Specific 04-11-2011, 03:59 AM
Replies: 2
Views: 420
Posted By bigdoug42
Just to double check..cam tower installation question

While reinstalling the intake and exhaust cam towers I noticed that i can't get the tower to sit down flat on the head to bolt it. I assume this is because the cams are still in their locked timing...
Forum: New Member Introductions 03-27-2011, 05:08 PM
Replies: 10
Views: 462
Posted By bigdoug42
You know, Doc, your FAQ is one of the best items...

You know, Doc, your FAQ is one of the best items I have ever seen on Aleros. Good Job!
Forum: New Member Introductions 03-26-2011, 10:26 PM
Replies: 10
Views: 462
Posted By bigdoug42
Probably (IMHO) because of the traction control...

Probably (IMHO) because of the traction control and abs. With the fat tires, its the best handling snow car I've ever owned.
Forum: New Member Introductions 03-26-2011, 07:38 PM
Replies: 10
Views: 462
Posted By bigdoug42
Erie county, You know, I don't have any pics...

Erie county, You know, I don't have any pics right now, will try to get some when the head gasket thing is done.

/Not a fast mechanic but a thorough one/
Forum: New Member Introductions 03-26-2011, 02:30 PM
Replies: 10
Views: 462
Posted By bigdoug42
Hey all

New guy here, from the heart of the rust belt, Northern Ohio. I have a 2001 Alero GL2 sedan in Ruby Red, with 140000 miles on it, bought it new in 2001 and its been a darn good car, up until the head...
Forum: LD9 2.4L Twin Cam Specific 03-26-2011, 02:19 PM
Replies: 5
Views: 621
Posted By bigdoug42
Thanks for the reply, The gear is tight on the...

Thanks for the reply, The gear is tight on the crankshaft, no slop, and I cant see much wear if any on the sprockets or gear. The guides are good, tensioner is good, will replace the tensioner shoe....
Forum: LD9 2.4L Twin Cam Specific 03-25-2011, 10:24 PM
Replies: 5
Views: 621
Posted By bigdoug42
timing chain question

Hi all, new to this site, lots of good advice, been lurking for awhile. My question is this: can (or should) I reuse the camshaft sprockets and the gear on the crankshaft when I replace the chain? I...
Showing results 1 to 21 of 21

 
Forum Jump

All times are GMT -4. The time now is 06:48 AM.

Contact Us - Aleromod.com - Archive - Top

Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
vBulletin Skin by vBSkins.com