[Rubered00]

Yes i am 110% sure it is just the rears. No i did not bleed the system at all. I heard this was kinda hard...And what affect would it have???

They taper on them was pretty big...like at it's lowest point i think it would be to the point where the squeaker would be hitting. So i HIGHLY doubt that has happened though. Good thought though.

2fst4u....Is your just the rears too??? See the pads that i had on the back when i first put them on were just the factory replacement ones (would that have been semi metalic) if so, they make the same noise too. However i noticed something on them when i took them off, it looked like the edges had began chipping off, on the pad to the outside of the car, the edge at the back of the car was. Then on the inside pad the opposite edge was chipping. I dont know what this means??? Anyone???

On the rotor on both sides of the rear i notice 2 lines that are probably....1/8 of an inch apart maybe a bit more. These 2 lines do not line up with anything that i can find and they were NOT there when i installed the rotors.

Someone told me that my callipers may not be releasing pressure and that it might 've been doing it for awhile but i just noticed because of the new rotors. But that makes no sense cause then my other pads would've been extremly worn AND i wouldnt that that the noise would get louder when i brake.