it's not hard at all. mounting the front is a matter of drilling two holes on top for christmas tree clips, drilling two holes on each side at the fenders for bolts. Then the back is drilling a couple holes around the inner tire well, and also more christmas tree clips along ledge of the trunk. be sure to paint your back bumper bar black as it will be seen. also, make sure you use the styrofoam under the bumper cover on the front. don't use it in the back tho. the sideskirts need screwed into each end, and you'll have to remove a little bit of material on the inside of the fiberglass skirt. screws go in the ends, and apply some panel bond underneath when the go on for good.(urethane adhesive works pretty good for this)
hope that helps.
|