http://invision.aleromod.com/index.php?showtopic=4288
the way i posted takes care of drl's
as far as the automatic nighttime lights
I'm not sure if this works on aleros, however it does work on some GA's apparently
ALC bypass
at connector C2 find A3 the yellow/black wire, and B2 light green/black wire.. be careful because there are two light green/black wires on that connector.. the one you want is closest to the yellow/black wire.
cut these wires again leaving as much wire as possible attached to the BCM.. simply tie the two wires together and tape them up real good. (this is the same thing as removing ambient light sensor and adding a jumper wire)
The BCM will now think that it is daylight all the time and it will not energize the relay to turn on the headlights.
independant fogs instructions are available just PM me. Most people have been concerned about DRL and ALC bypasses..