No one really has a how-to on this. There was a group buy through Anderbra but that went south pretty quickly. It basically consists of having to take out the lense, make a mold of it, then use a molding plastic to make a new one.
If you go that route, it would be best to use LED's because the coloured bulbs won't show up as well without a coloured lense behind the tint.
I have been looking into doing that myself and it will take quite a bit of work so I won't be able to start doing anything like that till end of July-ish.
This is definitely a lot trickier than clearing the corners so do the research well and if you would like, I have a few websites that look like they are alright on how to make molds and stuff but haven't had much of a chance to read through them. This is definitely gonna be a summer project. If you find some stuff out post it so we can get a collective research going and eventually put a how to up if you are interested.
__________________
SOLD - 1999 GL Sedan-LA1 3400
Installed - CAI, drilled and slotted rotors w/ Carbon fibre brake pads.
OWN - 1996 Rover 414 - replaced engine with a 1.7TD Isuzu lump and gearbox, Uprated brakes, Custom seats and interior trim, MG ZS 11 spoke wheels, Custom bodywork, Custom LED taillamps, Custom gauge surround to hold 2 52mm gauges (filled with boost and oil pressure gauge)
|