http://s1089.photobucket.com/albums/i359/pjwallington/?action=view¤t=P120611_1256.jpg (Picture of current setup)
I bought a performance air filter yesterday. The inlet hole is 3" Diameter, but wouldnt fit my factory intake tubing..
So I removed it and the air box ( Plus the IAT Sensor> Intake Air Sensor)
The question is.. Can I drill a hole just before where I placed the filter ? Or could I buy 2,1/2" Steel piping and put an 'S' bend in it and place it over behind the Battery where the Air box 'Was' ?
As of right now, i removed the sensor from the factory intake, plugged it back in, and have it taped on the far side of my battery (Noob-ish of me
)
Help would be much appretiated (My car is the 5-speed MAN) .