[-Alero-]

i recently just put on springtech springs, and i took care of the front no problem, and i got the back ones on eventually, but there is still one problem...... the screw that tightens up the strut, all the way at the top will not tighten, past hand tight. i mean i have tightend it a little bit past hand tight, and if i try to tighten it even more, it just spins the strut piston along with the nut. i noticed the only way to tighten or loosen this screw is if there is pressure from the springs pushing on it. so do you think maybe i should drive it around for maybe 5 minutes and try to tighten it up? because i have everything in place and ready to go, i just havent tightened those big bolts up past hand tight. (this problem is for both the rear struts)