all you have to do is add a pin on the pcm, which I believe is Clear 21, extend the wire and run it to one side of a switch, and run a wire to ground on the other side of the switch. When you flip the switch on, it grounds Clear 21, and you are in p-shift mode.
for the pins, the best thing to do is to use a pin from a spare pcm connector. i have a whole bunch of these, think I should sell these pins on the site? $1 seem fair?
__________________
www.milzymotorsports.com
1999 Z34 - 3800 Turbo - Under Construction
1999 Grand Am GT Turbo race car - 12.1ET on stock engine with 10psi!
1977 Corvette - LS1/LS6 T56 - Under Construction
|