View Single Post
Old 05-30-2014, 08:51 PM   #162
GX Member
Caboose73's Avatar
Join Date: Apr 2010
Location: Mass
Posts: 157
Caboose73 is on a distinguished road
Send a message via AIM to Caboose73
Well ive been browsing on summit racing and it looks easy enough to make a log manifold and have it exit on the pass side but im not sure how to get an exhaust flange and can start off of i tried ebay and i could only find eotec ones. Im not sure if i can cut up the stock mani and use that flange or go to a maching shop and just give the the gasket and tell them to cut a 1/2inch plate.
Stupidity has an incredible ability to overcome almost any obstacle.
Caboose73 is offline   Reply With Quote