Looking to get 4K for everything,
3K for the engine and all the extras I have in the garage... which is a lot.
1.5K for the Charger
Of course an immediate buyer can negotiate.
Bottom line is they need to go so I'm motivated.
The problem with the RSM Shaft bearing has been addressed. They put a cheap 305 bearing on the pulley side , and after a failure and shaft replacement that was corrected immediately.
I'm all ears for parting out the lot but I would like some commitment before that happens. I'm even willing to truck it to the buyer as long as it's not too far
I'm not n Central Florida.
This would really transform any Alero, GrandAm, J Body, Monte Carlo.
Even kit cars such as the Arial Atom are using the 3400
Thanks for looking
Last edited by BlackV6 : 07-04-2017 at 07:25 AM.
|