Quote:
Originally Posted by spc2125
since its a flat surface, id be afraid the wheels would roll if you ever banged ur car or something. or even if you were pulling a bolt too tight.
|
there is a lip that it would have to roll over...it is cupped around the tire on the top...these really wouldn't be that difficult to make...you would need some 3 inch angle iron, some 3 or 4 inch pipe, some expanded metal or whatever you want to use for the top, and a nice sturdy pin such as a pto pin for a tractor, after a little time with a welder you have some for cheaper than you could buy them