[Eh_nigma]

Just finished for the day... wow!

I finished the initial red-leather for the top part of the console... a bit of fiberglassing too... the bottom half has been cut, and tomorrow the 'vents' will be fiberglassed and black leather thrown onto that...

The 'flat decking' where the back seats were measured up and I'll be welding the initial grate hopefully tomorrow.

I measured out the 'kick panels' for the doors as well. Tomorrow the two pieces of stainless steel will be cut, then sent for sandblasting. "Racing Reaper" will be left polished on the driver side. Problem is the cut for the reflector may pose some problems. We'll see.

The new shifter shaft is being sent away for chroming as well... should have that in a couple days. As well, the shift knob will be sent for sand blasting as well once the "kick panels" are ready.

Oh, and I had a couple beers too..