[cavaliers60]

Originally Posted by cavaliers60

Well obviously, the first thing I did was order the LED Strip from Oznium.com. I got the 9.7"? one and the 1.2" one so I had enough to go all the way accross. Then I cut out a piece of Luan to fit inside the 3rd brake light assembly seen here:



Put adhesive tape on the back of the LEDs and taped it on the Luan. I also glued down the wire for the 1.2" strip.


Next, I took off the light bulb assembly and ran the wires through one of the holes in the back.





The rest is a piece of cake. Just wire it up to the 3rd brake light plug and you are good to go.

here you go lonnie.