Aleromod.com - View Single Post

04-06-2005, 01:57 PM

Ok, this is going very bad.

I found the solder, but no solder gun. My neighbor who probably has one isn't home.

So, I figure I can still run the power wire through the grommet. I found it on both the driver and engine side, and I read an old thread where Formula Nerd said to use a hangar to push the power wire through, it only takes 2 minutes max.

I have no friggin clue how to get at this from the engine side. I can see it from above the engine, then I jacked it up so I could get under the car, but I have no idea how I am supposed to reach this thing.

I'm already starting to wish I just taken it somewhere to get put in, and I haven't even gotten to the speaker wiring yet.

04-06-2005, 01:57 PM	#36
jiffy Posts: n/a	Ok, this is going very bad. I found the solder, but no solder gun. My neighbor who probably has one isn't home. So, I figure I can still run the power wire through the grommet. I found it on both the driver and engine side, and I read an old thread where Formula Nerd said to use a hangar to push the power wire through, it only takes 2 minutes max. I have no friggin clue how to get at this from the engine side. I can see it from above the engine, then I jacked it up so I could get under the car, but I have no idea how I am supposed to reach this thing. I'm already starting to wish I just taken it somewhere to get put in, and I haven't even gotten to the speaker wiring yet.