Aleromod.com - View Single Post

Cyber Knight · 11-03-2005, 11:55 AM

Step #2 (refer to above pics) - Take the clips from pic #3, attach the top of the clip to the straight bar of the bench bars. The bar that is bent around the straight one will rest in the bottom grove of the clip. A bit of force is required to get that in place, but it will snap in when lined up properly.

Step #3 - Line up the bench pieces with the clips now installed as seen in pics #4a and #4b with the floor mounts shown in pic #5. Make sure the back of the bench is under the back rests and the seat belts are in between the seat gaps. Now press down on the bench and the 2 clips should lock into place.

That's it, you're done!

11-03-2005, 11:55 AM	#4
Cyber Knight Swank Join Date: Jan 2004 Location: Alberta, Canada Posts: 921	Step #2 (refer to above pics) - Take the clips from pic #3, attach the top of the clip to the straight bar of the bench bars. The bar that is bent around the straight one will rest in the bottom grove of the clip. A bit of force is required to get that in place, but it will snap in when lined up properly. Step #3 - Line up the bench pieces with the clips now installed as seen in pics #4a and #4b with the floor mounts shown in pic #5. Make sure the back of the bench is under the back rests and the seat belts are in between the seat gaps. Now press down on the bench and the 2 clips should lock into place. That's it, you're done! __________________ If you don't stand up for something, you'll fall for anything. I don't have the Alero anymore, now I drive this