View Single Post
Old 08-05-2016, 01:32 PM   #15
zzyzzx
GLS member
 
zzyzzx's Avatar
 
Join Date: Mar 2008
Location: Baltimore, MD USA
Posts: 5,529
zzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond reputezzyzzx has a reputation beyond repute
Some pics from the Factory Service Manual and other to make it easier for the next person:

As you can see, the Factory Service Manual refers to it as an Inflatable Restraint IP Module (Passenger Inflator Module).

Here is the schematic which shows with fuses to pull:


They are on the left size door fuse panel:


Pull the G and K fuses:


Having said that, the Factory Service Manual says to only pull the Air Bag Fuse (the upper one of the two fuses, shown above, marked as G on the cover), but them mentions that you will see the air bag light on. I think if you pull both I mention probably not:



From the Factory Service Manual on how to physically remove and install the passenger side air bag:


As for how to remove the glove compartment (#2 above):

This fails to mention the 6 bolts holding it on (use 7mm socket), and then the electrical connector for the glove compartment light bulb.

Last edited by zzyzzx : 08-07-2016 at 11:23 AM.
zzyzzx is offline   Reply With Quote