Aleromod.com - View Single Post

[ion] C2 · 05-28-2014, 11:15 AM

Good luck fitting that downpipe with the 4-bolt to v-band adapter in the engine bay.

Also whyyyyy is your head and Cometic gasket sitting there like that, prone to being scratched up or otherwise damaged and get debris in the layers of the gasket? Aghhh..

When you install, remember this:

Head and block perfectly flat, shiny.
Copper spray the outside of the gasket (both head side and block side)
Torque to 88 ft-lb in THREE equal steps.

05-28-2014, 11:15 AM	#152
[ion] C2 636 whp Join Date: Aug 2006 Location: AZ Posts: 11,875	Good luck fitting that downpipe with the 4-bolt to v-band adapter in the engine bay. Also whyyyyy is your head and Cometic gasket sitting there like that, prone to being scratched up or otherwise damaged and get debris in the layers of the gasket? Aghhh.. When you install, remember this: Head and block perfectly flat, shiny. Copper spray the outside of the gasket (both head side and block side) Torque to 88 ft-lb in THREE equal steps.