View Single Post
Old 09-25-2006, 01:02 PM   #1
Mischief007
GL Member
 
Join Date: Apr 2005
Location: London, Ontario, Canada
Posts: 762
Mischief007 is an unknown quantity at this point
Send a message via MSN to Mischief007
How-To: Repair broken sash and clip on 2-door Coupe, back part of window sagging.

Tools needed:
Phillips screwdriver
Flat head screwdriver
10 mm socket and wrench

Parts needed:
GM part number: 22697622 <-- this is the clip that went on the back of the window
GM part number: 22689012 <-- this is the sash that the window slides into

Step 1 is to take off the door panel. Most of you should already know how to do that. There's 3 screws. One behind the reflector, and two behind the door handle. There's a plastic piece that pops out where the door handle is. The rest are the wonderful snaps. Snap off the arm rest with the power windows and mirror, unhook those switches. Take off the panel BUT DO NOT pull it completely away from the door. There's two more switches. One for the door locks and one for the trunk release.

Now, what worked for me is to lower the window half way down and umm...duct tape it . I used duct tape on the window and trim pieces. No damage but some paint chipped off. That was my dad's fault though. . You can also use scotch tape. Safer.

Step 2 is to mark off where the sash should be so that you can take it off. The sash was half the problem that broke. As you can see it snapped into two pieces. Use a flat sharp spade and hammer and carefully knock it off. I stress carefully. You don't want to break the window as well .



Gee I wonder what broke. (old plastic clip)



The new sash . ($17 CDN)



After the broken pieces are out, I advise you to pull the regulator out from the back side of the door. Taking out half the regulator made it 100 times easier. You will see a metal piece in black color with three screws on it. Unscrew the 3 screws and pull on the top piece so that you can pull out that metal piece.

Here's the easy part. Bend the cables to pull half the regulator out. Takes a bit of messaging but it will come out with no problems.



Now you can attach the plastic clip and the metal piece. The hard part; there's a little ball thing that goes into the clip. Massage it into the clip. The ball thing sits on the cable itself. You will see why I said to lower the window half way. This is what makes the clip go up and down with the window and the sash.

New clip is in place, at $65 CDN a clip.





At this point, bend the whole thing back into the door and replace the black metal piece. Clean the window on both sides, apply some glass primer on the window, apply body primer to the sash, and then fill the sash with urethane. That's the perfect way. I couldn't find anything because all glass shops were closed on Sunday. So I went to a carparts store and bought some all purpose sealant/adhesive. The guy knew what I wanted and told me that this should do it. I cleaned the window and applied this sealant.

I put the sash back on the window next to the tape and then attached the screw from the sash to the metal part of the clip.

Remove the duct tape or scotch tape, roll the window up and re-assemble everything.

The window has now been up for 24+ hours and I tested it successfully. Works like a charm.
__________________
2004 Pontiac Grand Prix GTP CompG -- Supercharged 3800 V6
??,??? km
??,??? miles

Last edited by Mischief007 : 03-12-2008 at 05:33 PM. Reason: Updated pictures...sorry.
Mischief007 is offline   Reply With Quote