Correct, I'm doing the rear bar, wheels are off and car is in on stands so I haven't bolted up the endlinks. I also unbolted the charcoal canister/evap box to give me plenty of room to manouever the bar.
I'm just trying to bolt down the brackets as pictured. I just took a quick pic holding the bar up with one hand so the bushing isn't fully seated in the bracket. But what you can see is that when I insert the tab at the top the whole bushing and bracket is at an angle and I can't clear the bottom bolt into the slot in the bracket. Even with a lot of force I can't push it up into place. Is there any method to get it seated properly? Thanks.
|