[tw0123]

just saw this on the "everything you wanted to know about your car" thread posted by lonnie...
here are the torque specs for the bolts when doing the front sway bar:

1. Raise and suitably support the vehicle.
2. Remove the front tire and wheel assemblies.
   
   Click to Enlarge
3. Reposition the intermediate steering shaft seal in order to gain access to the lower pinch bolt.
4. Remove the lower pinch bolt from the steering gear.
5. Support the front suspension crossmember with a suitable jackstand.
6. Remove the rear mounting bolts from the front suspension crossmember.
7. Remove the center mounting bolts from the front suspension crossmember.
8. Remove the front mounting bolts from the front suspension crossmember.
9. Lower the front suspension crossmember approximately 15 cm (6 in) by adjusting the jackstand down.
   
   Click to Enlarge
10. Remove the retaining bolts and stabilizer shaft insulator brackets.
11. Install the new stabilizer shaft insulator brackets and retaining bolts.Tighten
    Tighten the stabilizer shaft insulator bracket bolts to 66 N·m (49 lb ft).
12. Install the front mounting bolts to the front suspension crossmember. Hand tighten the bolts.
13. Install the center mounting bolts to the front suspension crossmember. Hand tighten the bolts.
14. Install the rear mounting bolts to the front suspension crossmember. Hand tighten the bolts.
    Tighten
    1. Tighten the left rear bolt to 110 N·m(71 lb ft).
    2. Tighten the right rear bolt to 110 N·m(71 lb ft).
    3. Tighten the left front bolt to 110 N·m(71 lb ft).
    4. Tighten the right front bolt to 110 N·m(71 lb ft).
    5. Tighten the center bolts to 110 N·m(71 lb ft).
    6. Tighten the stabilizer shaft insulator brackets bolts to 66 N·m(49 lb ft).
15. Install the lower pinch bolt from the steering gear.Tighten
    Tighten the bolt to 40 N·m(30 lb ft).
16. Install the front tire and wheel assemblies.