[sleepyalero]

okay paul, I was messing around in the driveway. idle, and tried to do an idle scan with the new CFG you sent over.

few things I have noticed. when I tried to scan, the WB became an unsupported parameter. when I would delete it, reload it, save CFG then scan it would then work.

after the scan (remember only idleing and a few small revs) I would go into histo's and the maf afr error was not available, it said unsupported.

BUT if I did a scan with the fuel trim cfg. then open that log file in scanner, and open the sleepyaem cfg, I then could view the MAF AFR error from the idle scan.... so a little confused here....

I tried to redownload and save the cfg and use it, still same issue.


so I need to know, should I keep scanning with the fuel trim file. then look at it through the sleepyaem cfg or??

if no answer from you soon, I will just use fuel trimming cfg then look at results through sleepyaem cfg...


Oh and the the LAMBDA gauge did not read at all