Quote:
Originally Posted by spc2125
And yes i know.....
Im planning on taking the head off and bringing it to a shop, or worst case i buy a used head from a guy on ecotecforum.com
But one i take the head off and have it machined, then ill change all the gaskets and put in new head bolts.
|
That sounds good
You do have a torque wrench/ratchet as jawa told you?
If not get one because you can't just tight the head bolts & forget about it , it needs to be torque specification no way around this one or you'll get in to engine trouble
Also since JLw7123 offer his help take it if you need to & specially if you not sure on how to do all of this
Might be a bit of a "big" job but done correctly you'll be happy or your self & more knowledge to you