View Single Post
Old 03-24-2011, 06:29 PM   #1
RisenequinoX
GL Member
 
RisenequinoX's Avatar
 
Join Date: Apr 2009
Location: Youngstown, Ohio
Posts: 607
RisenequinoX is on a distinguished road
Send a message via AIM to RisenequinoX Send a message via MSN to RisenequinoX
How To: Fix cruise control after LED Tails

This is a fairly simple how-to. I finally decided to not be lazy and figure out why my cruise stopped working.

This is a fix if you lost your cruise control after putting LED bulbs in your tail lights.

You will need:
Load resistors (i used 25w at 10ohms) Quantity depends on how many LED Bulbs you have (1 for every bulb), Wire splice connectors (2 per resistor), Something to mount the resistors to your car (i used 3m doublesided tape)

Outside tails:
1.) Take one side of the load resistor and clamp it to the Ground (blk) wire on the bulb connector and the other side connects to the A wire (light blue on mine) The Bulb connectors are labeled A - B - G. You want the resistor to go between A and G.



Inside Tails:
2.) This one is easy, just do the same as above, but there are only 2 wires so its a no-brainer.





Third Brake Light:
3.) Same as the inside tails, just put the resistor in between the ground and power.




4.) get in your car and test it out!


Hope this helps as this is my first write-up!
__________________


100,000 Mi 3/29/2011

Last edited by RisenequinoX : 03-24-2011 at 10:13 PM.
RisenequinoX is offline   Reply With Quote