Aleromod.com - View Single Post - Grill Mesh- Do It Yourself

Fuzzyspudkiss · 03-31-2011, 08:26 PM

I put the grille mesh on my car because it was a cheap and easy mod ($7 + a couple cuts on my hands). It looked good and I got quite a few complements on it. I did it last summer, well after about 4-5 months I noticed that the drivers side mesh started to rust? Has anyone else had this problem...

I noticed that there is some sort of condenser/radiator piece behind the fogs where it is rusting. Could this be the cause of it or am I not using good enough gutter guard? The other one is perfectly fine...

I have the 3.4 L engine if that helps get the orientation of stuff.

This is an old picture but the rust was already starting its much more noticeable now...and yes it was falling down but it isn't normally like that lol

03-31-2011, 08:26 PM	#91
Fuzzyspudkiss GX Member Join Date: Jan 2009 Location: Covington, IN Posts: 180	I put the grille mesh on my car because it was a cheap and easy mod ($7 + a couple cuts on my hands). It looked good and I got quite a few complements on it. I did it last summer, well after about 4-5 months I noticed that the drivers side mesh started to rust? Has anyone else had this problem... I noticed that there is some sort of condenser/radiator piece behind the fogs where it is rusting. Could this be the cause of it or am I not using good enough gutter guard? The other one is perfectly fine... I have the 3.4 L engine if that helps get the orientation of stuff. This is an old picture but the rust was already starting its much more noticeable now...and yes it was falling down but it isn't normally like that lol __________________ Last edited by Fuzzyspudkiss : 03-31-2011 at 08:35 PM.