View Single Post
Old 09-16-2011, 10:46 PM   #1
AleroB888
GLS member
 
AleroB888's Avatar
 
Join Date: Nov 2007
Location: Fort Knox area, KY
Posts: 2,120
AleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond reputeAleroB888 has a reputation beyond repute
7x Crankcase Position Sensor (cps)

Got around to changing this. Not that I'm sure it needed it, just on general principle. The original looked OK, but as long as it was out, I went ahead and stuck a new one in there. (but I compromised, used an Autozone one )

I was able to get a wrench on it in there. You have to pry off a clip that sits on the top of the bolt first, they route another cable thru at the same spot.



Clean area around the sensor, remove bolt. Gently twist sensor as you pull, should come out easily.



The original looked OK, once the oil was wiped off:



Very tight quarters in there, got scatched up a bit.

Hint: attach plug to new sensor before installing it.

Feel free to add info, just thought I'd snap some pics in there.
__________________
2003 GL MP62 supercharged / 2004 GLS stock
http://www.youtube.com/watch?v=hpVYZPbpPzk
AleroB888 is offline   Reply With Quote