[MiLo]

Originally Posted by Vella's Alero

Yes, if you take out the spark plugs then you should be able to shoot out the water from the cylinders when you turn over the engine. You have to be careful though if anything is bent (con rods, etc...) Also check any computers that might have been fired or fuses that could have blown due to shortage.

Good luck with it!

Now that I know what its called " hydrolock" I'm looking on Youtube and they all seem to be ok by doing this when Their engine gets flooded. Where/when do I have to worry about bending rods warped pistons etc? Is it over turning the engine minutes at a time trying to get the water out? this is when I would think it would happen, heat + no lube = bending/warping. Should I do it in say 10 sec intervals?