Quote:
Originally Posted by joserivas19
I think I need some guidance on this one Silver, i did everything as written using a 3300 ohm resistor. when i went to start it, it didnt start because the light was flashing. so i waited the 10 mins for it to clear. Once it cleared i turned the car off and when i went to restart it, NOTHING!!! everything is blank. I have no lights of anything come on, no click, nothing.
Any ideas what it could be?
|
1. The non-solder instructions say to use a 2200 ohm resistor.
2. Did you turn the ignition off for
5 seconds between the security light clearing and trying to restart your car?
3. Try the 30 minute learn procedure that is posted at the bottom of the instructions
4. If the above 3 options do not work, you have a fault in your bypass that you built, BCM problem, or PCM problem.