View Single Post
Old 11-05-2016, 01:01 AM   #69
00redse
GX Member
 
Join Date: May 2005
Location: Phoenix AZ
Posts: 120
00redse is an unknown quantity at this point
Also i forgot to show the part directly below the door strike is cut out too on the rear. it sits so low now its perfect. i was never really at the height Richie had it at until now. I didnt want all that hard work going to waste, so its now back on easystreets and sitting low as hell. Actually it is on stands again while putting in ball valves and schrader valves on each corner. now I can isolate each corner if there is a leak or compressor fault and then fill it up like a tire. Also should be able to use the ball valves as a speed reducer too so it doesnt always have to be set up to lift super fast either. Big valves are fun to show off at first, but slow adjusting is nice too sometimes.
Also, I have some 18" centerline dynos I can throw on and check clearances, but it should be a similar overall diameter either way. the 20s have a tiny sidewall and are only 7.5" wide. I need one more tire for my centerlines though.
00redse is offline   Reply With Quote