This is the How-To for putting LED’s in the map cubby on the Alero door.
Level of Difficulty: Moderate.
The tools required are: a hobby tool kit. (screwdriver bits, torque bits, and sockets),3/32” + 13/64” drill bits, a soldering gun, wire strippers, a long screwdriver (any type), a dremel;file;or sand paper, and a pair of pliers.
Materials Required: 3 LED’s of your color choice, Duct tape, Super glue, several lengths of wire (I’m using 18ga speaker wire)
Step 1: Open your car door, in a location that it will not get hit or damaged in! Pop off the cover under the inside handle. (just below the handle to open the door) and reveal 2 large screws. The other cover is the red reflector in the bottom corner. Just put a screwdriver under the edge and pry it up.