quick question

[tudski]

aright so my battery in my alero is the type were the pos. and neg. screm into it, and i was wondering if the posts that u use to screw into the battery have a charge so that i can put a post terminal on it run a power wire. might not understand wat im saying but i can find a picture of the correct battery to point out wat im asking.

[heineck]

u talking about for an amp

[tudski]

yeup and i need to know if it put outs current at that post.

[Misuseofyou]

Yes, you connect your amp's power wire to the positive post. With a fuse.

[tudski]

so that post does have a charge? cause i have the power wire just wedged in between the bushing(car powerwire for component stuff..ie. starter, etc) and the terminal

[heineck]

ur gonna need a fuse, if ur usin an amp kit it should come with one

[tudski]

i know i have it already setup its working but i want to make it look nicer clean up the wires, so thats why i was wondering.

[Misuseofyou]

Its hard to understand what you mean. You crimp then solder a ring terminal on the end of your wire, then unscrew the post, put the ring on the bolt and screw it back in.

[tudski]

thats what i have now done but i want to get somethign liek this so i can have multiple runs to multiple amps
http://www.sonicelectronix.com/item_...+Terminal.html

[heineck]

my freinds amp kit came with that

[AbHeLlRaZoR]

you can use a different type so that you don't have to run multiple power cords to the trunk. EDIT: Try a Distribution block

[Misuseofyou]

I have 4 diff wires connected to my positive terminal without buying one of those.