Well I got working on my 086 head. I decided not to port the exhaust port to much. So its just a small port and polish. But I did sharpen up the splits.
Lots of work and time than you think! After a few beers and two days of working this is where im at so far.
Its not perfect but it came out good! Exhaust port
Intake ports
Plus I was limited to the tools that I had after I used up what I had and I was on a budget. So I had to improvise
__________________
I love the smell of burned rubber...except when I gotta replace my tires
Nice I've been thinking of having a former co-worker of mine port and polish my head for me and maybe rebuild the whole valve train with cams. I don't know if I should but he does really good work.
Not bad looking. You want the intake splits to have a nice rounded edge to split the air evenly and the exhaust splits should be knife edged to a sharp point. I know you have limited tools, but you may be able to pull it off.
__________________ CARDOMAIN W/ DRAG VID & LIST OF MODS
Trevtec Motorsports built & driven - LV,NV Revolution Lounge @ the Mirage
Promoter - PM me to be put on the list. Ladies first drink free wed, thur, sat
Well I didnt really do much porting, the only porting was done to the splits to sharpen them up. I sanded and smooth out the walls and polished. Now if I had did a big porting job then yes I would test it.
__________________
I love the smell of burned rubber...except when I gotta replace my tires
Well I didnt really do much porting, the only porting was done to the splits to sharpen them up. I sanded and smooth out the walls and polished. Now if I had did a big porting job then yes I would test it.
You still could've changed things quite a bit more than you think. It's your head though.
__________________ CARDOMAIN W/ DRAG VID & LIST OF MODS
Trevtec Motorsports built & driven - LV,NV Revolution Lounge @ the Mirage
Promoter - PM me to be put on the list. Ladies first drink free wed, thur, sat
Linear Mode
