Contact ZZP and find out if these will fit, and if they're the correct impedance. Most important thing to consider.....o-ring diameter, distance from intake seat to fuel rail seat, and voltage. If the clips dont work, dont worry about that, I rewired my whole setup with adapter clips from Summit.
ZZP states specifically that they're flow matched, however, Milzy doesn't state if theirs are or not, and Milzy also says "
In order to run these better-flowing "Bosch style" injectors, custom fuel rail brackets and wiring harness adapters are needed." I don't believe that is the case with the ZZP's, even so, they offer the clips with the injectors for $50 cheaper than Milzy.
Try these #36's from ZZP:
http://www.zzperformance.com/grand_p...ts1.php?id=323
The set of 6 is $160, and you can get them with the connectors for an extra $40. Not a bad deal really.
Home rewiring with new clip set on the #42.5's (not the ones you asked about, but I know with your skills you can rewire your setup.)