Overlay Installation

[XanderWiFi]

Very much appreciated Phil.

All I have left is to soder. Can someone verify that it is the gray and black wire to the cubby hole light that I will be sodering to?

And what is the best way to three way splice? I want to replace and use that bulb

[Philbar71]

No problem.

And if I recall... It's just a solid grey wire for all illumination through out the car... But, wait for somebody else to chime in because I could be mistaken.

[XanderWiFi]

Shoot need to read my own thread. Grim says yea at the top...here goes...first sodering try. Nervous as heck.

[XanderWiFi]

Thank you everyone for your input and assistance in this endeavor. I learned some new things and boosted my confidence quite a bit-especially pertaining to electrical since this was my first time soldering.

On to the next project!

[Ttop191]

looks good bro, props, you are learning

[cherrington17]

[XanderWiFi]

The power box buzzing is loud and irritating lol.

[cherrington17]

so remove it?

[XanderWiFi]

No there is actually a switch that allows you to change between light shades. One requires the power box, the other doesn't. Both look sharp.