Turn Signal...

[Trickyslick]

Okay I have searched around but I can't find anything...my hazard switch was freaking out and would start clicking randomly so I just unhooked it and lost my turn signals for awhile, I just bought a new switch from yallernot (sp?) I switched it out and it worked good for a couple day but now it is starting to freakout again. It will just randomly start making a clicking noise (the lights do not flash). and it does not matter if you are going straight or turning. Is there something else that these cars are known for that I might have to replace or checkout??? Thanks.

No its not the blinker fluid....

[Gr1m]

umm ive never heard of that, sounds like you might have a short in one of the wires leading the the hazard switch

[Nate's Alero]

think it is nuts.... maybe haunted car?

[cherrington17]

on the harness that plugs into the switch.... the purple wire is the power to the turning signals. while i has my switch on order, i had a 12v constant wire plugged into that spot, and i'd have to manually click my signals.


now... if you managed to get a 12v clicking module (blinker) and wired it inline with a 12v constant... you could completely bypass the lights.



as a test, i'd probably run a 12v constant to that wire, and find out if its still acting up. if it is, is a problem somewhere prior to that harness... if not, you just got 2 bad switches. (i'm not saying yalero would sell you a bad one, it might have just gone bad afterwards, regarldess)

[Trickyslick]

Thanks it gets annoying...think I'll just start putting the old arm out the window to start turning...damn gremlins.