Brake light Issue.

Blown 346 · 11-04-2009, 08:12 AM

I made a post back in march regarding a issue where my ABS and traction light were on.

After getting under the car, I noticed the two wires that come out of the hub that connect to the ABS sensor were cut. I decided to try and splice some new wires in and re connect them. Got everything connected and the ABS still doesnt work.

Does this mean I need to replace the whole Wheel Bearing on that one side along with the connector?

If so, How difficult is this to replace?

colonel6632 · 11-04-2009, 08:26 AM

i have the same problem. my wires broke also. i spliced them and my lights are still on. i also replaced both front wheel bearings. So unless my back ones need replacing i don't think my splice worked very well

alero_bmxer · 11-04-2009, 08:31 AM

you need to get a new lead. i tried that but because the wire is like an angel hair doing a splice doesnt work right

Cliff8928 · 11-04-2009, 01:15 PM

Not to mention those wires are very sensitive to interference.. The ABS wires are twisted when running through the car to reduce the chance of any interference.