|
-2 screw un front by your feet right under where the dash meets is.
-2 screw inside the center console, take the bottom rubber mat out.
-2 screws b/t the seat and the console, on the side and closer to the back. slide the seats back all the way and you can get them.
-Pry out the u shaped pin on the front of the shifter. pull shifter up and off.
-pry (well, pop) off the trim around the bottom of the shifter. unhook trac button wire and bulb for shift indicator. lift out
-pull out center consloe up and towards back seat.
you will need a 1/4 inch rachet, forget what size socket, but all the screws are the same size, a long extension to reach into the center console hole, and a regualr size flat blade screw driver.
that help?
__________________
2001½ F150 XLT Crew Cab- true dual glasspacks with x-pipe, AEM intake, SCT X3 with VMP custom tunes, full stereo system, HID 55w heads and 35w fogs, 35% tint front and 20% rear, Lightning tail lights
04 F6 Sno Pro Team edition- MBRP race can, ODS clutch kit
01 YZ125- bored out to 144, PnP cylinder and head, Pro Circuit WORKS suspension, many other mods
|
Linear Mode
