Guage overlay wiring

alerogls001 · 03-13-2010, 06:24 PM

Ok so I'm ready to ground it and power it. The thread I was reading says to run power to the dimmer switch. When I take the left vent/dimmer/fog light out I see a wire harness going to the dimmer... So where exactly do I tap into the power?

alero_bmxer · 03-13-2010, 06:30 PM

just tap into the cubby light harness under the radio. any grey wire is switched 12 volts

pimpalero2003 · 03-13-2010, 06:38 PM

That's what I did used little taps.

alerogls001 · 03-13-2010, 07:13 PM

Gotcha. Thanks. Feel kinda stupid for asking this but what about grounding? All I see is a bunch of plastic molding everywhere.

alero_bmxer · 03-13-2010, 07:15 PM

i just used the ground wire in that same harness. havent had any problems and they've been in for 3 months.

alerogls001 · 03-13-2010, 07:39 PM

Thanks seems to be fine. I did end up using gray power on cluster harness as well. Couldn't even see the cubby harness due to everything from stereo and alarm install- which I didn't do. Info on gray being power helped alot. Appreciate the help guys!