|
jesus christ!! im dumb founded by what im reading and seeing
i-car is 2-4mm tolerance from point to point, 2nd ya measuring all worn and in the wrong places ya dont measure from the hood bump stop wow!!!
the main 3 things ya need to do to pull and square any strutcual part is this
lenght, width, height if ya dont have any of those nothing will line up
so go from rt side rear bolt on the lower hood hinge, to the first fender bolt and then cross to the other side
then for lenght go from a strut bolt and the bolt that mounts to the headlight mount panle
pretty simple remember 2-4mm tolerance
|
Threaded Mode