Hid Problem!

McMarcus · 07-02-2010, 09:55 PM

I hooked up everything properly on my HID's, i hope so atleast. And they wont light up, i dont have high or low beams, but still have my blinkers. It also cut off my Fog lights, and my check engine lights and my light for my High beams stay on and i cant click them off. I thought i blew i fuse, but i checked them and they are all fine. Any suggestions? I bought my HID's from DDM Tuning and they are 55W 9006, 8000k.

cherrington17 · 07-02-2010, 10:05 PM

have them wired backwards?

McMarcus · 07-02-2010, 10:11 PM

I dont think so, how would it be backwards? after you said this i flipped the plug-ins inside my headlight houseing (one that hooks up to stock bulb) and then i flipped the one going to the ballast.

Monza · 07-03-2010, 06:19 PM

To have all of those problems the BCM likely is pissed. I would put everything back original and see if the problems go away. If not, unhook the battery for a half hour and see if the BCM will reset. If not, the BCM may be toast.

If everything resets OK then begin this time with a plan for the correct polarity for everything before you try to fire them up again.

Cliff8928 · 07-04-2010, 02:12 AM

The BCM is irrelevant if the headlight switch is turned on. Did you unscrew any ground splice packs by chance?

XanderWiFi · 07-04-2010, 07:58 PM

Flip the on switch? : P

alero_bmxer · 07-04-2010, 09:52 PM

do you have the headlight harness plug plugged in?

bizarre179 · 07-04-2010, 11:13 PM

Flip the plug around. It has tabs on it, but ignore them. Thats what I did and they worked. The polarity is wrong.