Hazard Switch Replacement Instructions

Tools needed:
8mm socket
8mm end wrench
Flat head skrewdriver
GM Part Number: 22642606

Removal Procedure
1. Remove the center air louver deflector.
2. Remove the instrument panel cluster.
3. Remove the hazard warning switch bezel from the instrument panel using a small-flat bladed tool to release the retainers. (Optional)
4. Remove the left side bolt from the hazard warning switch through the instrument panel cluster pocket.
5. Remove the right side and center lower bolts from the hazard warning switch through the center air louver deflector pocket.
6. Reposition the hazard warning switch from the instrument panel to access the electrical connector.
7. Disconnect the electrical connectors from the hazard warning switch.
8. Remove the hazard warning switch from instrument panel.

Installation Procedure
1. Connect the electrical connectors to the hazard warning switch.
2. Position the hazard warning switch to the mounting points in the instrument panel. I found that it was easier to bolt the mounting bracket back into the car, once mounted I pushed the switch into the bracket and it clicked into place.
3. Install the left side bolt to the hazard warning switch through the instrument panel cluster pocket. Tighten
Tighten the left side hazard warning switch bolt to 3 N?m(27 lb in).
4. Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket. Tighten
Tighten the left side hazard warning switch bolt to 3 N?m(27 lb in).
5. Install the hazard warning switch bezel to the instrument panel pressing into place until fully seated. Install the instrument panel cluster.
6. Install the center air louver deflector.