going total led on tail lights.

[Cliff8928]

Originally Posted by Rexter9x

How would you go about changing the flasher? Where would you find a replacement that would work with leds, and what would be involved?

It requires splicing 3 wires on the hazard switch because the original is built in to it.

[bizarre179]

Sorry for diggin this up but i am having a problem trying to find the radioshack alternative resistor. I looked up 274.0120 and nothing . But with 271.0120,it pulls up an 8 ohm 20 watt resistor. Will it work?

[cherrington17]

http://www.radioshack.com/product/in...tId=2062288&cp

yeah... sorry about the typo. it IS 271.120. that is what you need. as is seen on the top left of the package, in the pic on the last page.

i'm an idiot who can't read my own pic.

[lonnie]

Personally I put Leds in all my tails and I like the fast flashing better.

[SittinOnChrome]

Originally Posted by lonnie

Personally I put Leds in all my tails and I like the fast flashing better.

me 2 - nothing is better than having your blinkers flashing fast on crack

[CiscoPath]

I always thought the fast blinking burn something out eventually.

[irondiezl3]

i just did both sides and still cruise doesnt work? i double checked wiring to.

[DRM Racing]

its very interesting that you said your cruize control dont work cause for some reason when I turn mine on it works for a bit then shuts off. I have LED buld replaced for all my lights. how would it be possible for the LED lights to cause an issue with the cruize control?

[sleepyalero]

IIRC people said you need to install resistors with the LED's because the car thinks that you have a bulb out in the back, therefor the cruise wont work.

Originally Posted by cherrington17

http://www.radioshack.com/product/in...tId=2062288&cp

yeah... sorry about the typo. it IS 271.120. that is what you need. as is seen on the top left of the package, in the pic on the last page.

i'm an idiot who can't read my own pic.